Proskit CP-373 Pro-Crimper Modular Tool (160mm)

Key Features

• Cutting modular cable: Place the single-bladed side of the tool's cutter facing you and cut the modular cable to the desired length..

• Make sure to cut the ends of the cord straight across, not diagonally..

• Stripping modular cable (Flat Cable): 2a. Insert 4P/6P cable into the two-bladed side of the tool's stripper until it touches the stop guide..

• 2b. Insert 8P cable into the two-bladed side of the tool's stripper and let it extend a little past the lower cut blade..

• Squeeze handles until it stops cable must be kept perpendicular and then pull from the tool..

• Stripping Round Cable Insert the cable into the round stripping hole, turn the crimper in counter clockwise direction and cable in clockwise at the same time..

• Remove the outer jacket, insert the stripped cable into the plug and be sure the left wire at one and matches the right wire at the other end..

• Place modular plug with cable into the tool's holder..

• Be sure the striped wire is between the tab and gold contacts. Squeeze handles until it stops..

• 4p holder is located on the back side of the tool..