Marking and measuring is one of the most critical parts that manufacturers deal with during construction or other manufacturing work. Without the right measuring and marking, the components may not follow the right design and become useless. This is why it is necessary to have an arsenal of marking and measuring tools. These tools provide precise measurement and even correct placement of components during the manufacturing process. Here, you can check the list of some marking and measuring tools that are important for the manufacturing industry.
Scribers: A scriber is a tool made from steel that is used to scratch the surface of metal and plastic lightly. While using scribers, it is recommended to apply a coat of engineer’s blue. It is a spirit-based liquid that is applied to a metal surface. When you drag a scriber across this liquid, it leaves a clean line that is easily visible.
Punches: If you want to drill a hole in the metal, centre punches can be used to make an indent in the surface. These tools provide a starting point for a drill and stop it sliding over the surface. Where dividers are to be used, dot punches can be used for marking centres. Dot and centre punches are quite similar except that their tips are ground to 60° rather than 90° point.
Squares: There are three types of squares available in the market:
- Try Square
- Mitre Square
- Engineer’s Square
Both try and engineer’s squares are used for the same purpose i.e. to mark lines at 90° to an edge. However, a try square is used on timber while an engineer’s square is used while working with metals. Both can be used on plastics. These squares can be used by holding the stock part of the square tightly against the edge that you have just cut. If there is light between two edges, a cut is not square.
Gauges: There are three types of gauges:
- Marking Gauge
- Mortise Gauge
- Cutting Gauge
You can use a marking gauge for making lines parallel to the face edge and sides of the wood. This tool consists of a stock that slides up and down to set the measurement. It is set using a steel rule having a zero end. The sharp point of a gauge is pushed into the wood along the length of the timber to ensure that you mark a parallel line.
A mortise gauge has two pins, one is fixed while the other is adjustable. It marks two parallel lines where mortise and tenon joints are to be cut. A cutting gauge is used to cut across the grain. It is used in the same way as a marking gauge but has a blade instead of a spur.
These are four major tools used for marking out and measuring. If you are planning to buy these tools online, browse through moglix.com and get the best deals of the best brands.
